the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. www.conwin.com product da ta sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors the connor-winfield pvl54i90g5 is a 3.3v voltage controlled crystal oscillator (vcxo) with differential pecl outputs. based on a fundamental design the pvl54i90g5 is designed for phased lock loop applications requiring low jitter and tight frequency stability. 1 2 pvl54i90g5 - 155.52 mhz vcxo series center frequency 3.3v operation low jitter <1ps rmstotal frequency tolerance: 20ppm temperature range: differential lvpecl outputs enable/disable functionhermetically sealed dip package rohs 5/6 compliant 0 to 70c 3 .3 v 1 4 p in l v p e c l v c x o o sc il la t o r w it h e n a b le / d is a b le f u n c ti o n pv l5 4i9 0g 5 vx576 00 09/18/06 ordering information features description cw 07 35 pv l54 i90 g5 15 5.5 2m absol ute m aximum rating s table 1.0 parameter units minimum nominal maxi mum units note storage temperature - 55 - 125 c supply voltage (vcc) - 0.5 - 7.0 vdc control voltage (vc) - 0.5 - 7.0 vdc operating specific ations table 2.0 parameter minimum nominal maxi mum units note center frequency (fo) 86.097902 155.5200 166.6285 mhz frequency vs. temperature - 10 - 10 ppm 1 frequency vs. calibration @ 25 c - 5 5 ppm 1 frequency vs. aging (10 years) - 5 5 ppm total freq uency tolerance - 20 20 ppm 2 operating temperature range 0 - 70 c supply voltage (vcc) 3.135 3.3 3.465 vdc supply current (icc) - - 80 ma jitter (bw=10hz to 20mhz) - - 5 ps rms jitter (bw=12khz to 20mhz) - - 1 ps rms ssb pha se noise at 100hz offset - - 80 - dbc/hz ssb phase noise at 1khz offset - - 100 - dbc/hz ssb phase noise at 10khz offset - - 130 - dbc/hz ssb phase noise at 100khz offset - - 135 - dbc/hz input characteristics table 3.0 parame ter minimum nominal maxi mum units note control voltage range (vc) 0.3 1.65 3.0 vdc frequency pullability @ 25 c +/ - 45 - +/ - 90 ppm 3 absolute pull range +/ - 30 - - ppm 4 monotonic linearity - 10 - 10 % input impedance 50k - - ohm modulatio n bandwidth (3db) 10 - - khz disable input voltage (high) (vih) - 2.26 - vdc 5 enable input voltage (low) (vil) - 1.70 - vdc 5 lvpecl output characteristics table 4.0 parameter minimum nominal maxi mum units note load - - 50 ohms 6 voltage (high) (voh) 2.26 - - vdc (low) (vol) - - 1.70 vdc duty cycle at 50% level 45 50 55 % rise / fall time 20% to 80% - - 1.0 ns packag e characteristics table 5.0 package hermetically sealed metal 14 p in package. notes 1.0 control voltage @ 1.65v 2.0 includes initial tolerance, deviation over temperature, supply and load variations, shock, vibration and aging. 3.0 referenced to fo at 1.65v, positive slope. 4.0 absolute pull range (apr) is the minimum guaranteed pull range of the vcxo under all conditions over lifetime operation. the apr is referenced to fo. 5.0 when oscillator is disabled the true output is in a low state (vol) and the complementary output is in the high state (voh) 6.0 output terminated into 50 ohms into vc c ? 2.0vdc or thevenin equivalent.
the connor-winfield corp . 2111 comprehensive drive. aurora, il 60505.fax (630) 851-5040. phone (630) 851-4722. www.conwin.com product da ta sheet specifications subject to change without notice. data sheet #: rev: date: page of copyright 2001 connor-winfield all rights reserved. a cr yst al controlled oscilla tors 2 2 vx576 00 09/18/06 1 0 0 c 1 5 0 c 2 2 5 c 2 5 c 1 8 3 c 3 6 0 s e c . m a x . 6 0 - 1 2 0 s m a x . 6 0 - 1 5 0 s m a x . t i m e t e m p e r a t u r e 2 2 5 c 0 t p r a m p - d o w n r a t e 6 c / s e c o n d m a x . 1 0 - 3 0 s r a m p - u p r a t e 3 c / s e c o n d m a x . f r o m 1 5 0 c t o 2 2 5 c . package outline solder profile output waveform pin connections t est circuit
|
